Many people would always think that their homes have traditional stucco without even checking if it is the right material used. This usually comes from builders who fail to inform the homeowners about what is synthetic stucco or otherwise known as EIFS are. They are not the traditional hard coated stucco and people simply assume that all stucco are the same.
The truth is most homeowners do not know what they actually like for their exteriors which is why you can find that builders would often use EIS instead. On the other hand, it is also important that you know what the difference between EIFS with traditional stucco is.
Being Aware Of What Traditional Stucco And EIFS Are
When you go to places like snapstucco.ca you can be sure that they will be able to tell you what the distinct differences are and they can also advise you on what is the best material to use on your home depending on your budget, the build of the home and also the location that your house is in.
Traditional Stucco And What It Offers To Your Home
The traditional stucco is a hard coated exterior system. It is very durable, powerful and also strong because it covers the home with layers of rock. Basically, the cement stucco comes from sand, portland cement and water, and also a small quantity of lime. This material provides fine-grained concrete that is attached to the house by a waterproof barrier paper, metal flashings as well as a galvanized wire mesh. The facade of the stucco is the primary barrier, but then there is also a concealed barrier that is able to direct any water that enters the facade.
What You Need To Know About EIFS?
EIFS use multilayer synthetic stucco that is softer when you compare them to the traditional stucco. Also, EIFS does not allow any water to pass back through its coating in form of vapor if moisture suddenly infiltrates the system. When you install EIFS, you will find that is has a base coat as well as a finish coat that is applied over an existing EPS board. The EPS board is then attached directly to the sheathing through fasteners or with use of an adhesive. This helps the barrier in blocking out water to drain behind the EPS board.